Medtronic 500 T Betriebsanleitung Seite 79

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 92
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 78
hstnm%lsns
op.mtlng
d.6Mllatw
.-I
rutomslsd
URPAK
SW
AED
is connected to a modem and ready to transfer data.
6-6
AED is connected to a printer and ready to print a report.
The
AED
has entered the test mode.
The external test load test has been successfully completed.
The
AED
prompt that follows the
IF NO PULSE
message.
See MOTION DETECTED.
The
b
The
b
TO SEND PUSH
AED prompt to move everyone away from the patient.
START CPR
STOP MOTION
TEST MODE
TEST OK
TO PRINT PUSH
AED
has analyzed the patient ECG rhythm and detected a shockable
ECG rhythm.
STAND CLEAR
The
AED
is in the setup mode. The nnnnnnnnnnnnnnnnnnn is the
nnnnnnnnnnnnnnnnnnn
Device Configuration code.
SHOCK ADVISED
The
AED
is transferring data by modem or to a printer. The transfer is xx%
complete.
SETUP MODE
The
AED.
The
AED
is transferring the setup to another
AED
successfully transferred data.
The
xx.xx
is installed.
The
very
low.
The self-test is being performed and software version
>o<%
COMPLETE
The battery voltage is
XX.%
SEND COMPLETE
SENDING
SENDING
BAnERY
SELF-TEST
AED
prompt to press
SHOCK
to discharge.
REPLACE
AED
is fully charged and ready to provide therapy. This is the
AED
has analyzed the patient ECG and detected a nonshockable ECG
rhythm.
Press ANALYZE to begin ECG analysis.
The
AED
detects motion during ECG analysis, thereby inhibiting analysis.
Setup mode message for motion detection option.
The
#xX
Setup mode message for the modem phone number option.
Setup mode message. You may select the configuration for one of nine
Hayes AT-compatible modems.
MOTION DETECTED
MOTION DETECTION
NO
SHOCK ADVISED
PUSH ANALYZE
PUSH TO SHOCK
The
AED
prompt that follows the CHECK FOR PULSE message.
The battery voltage is low.
Setup mode message for the modem initialization string option.
MODEM PHONE NUMBER
MODEM SELECTION
INIT
STRING
Setup mode message for energy sequence option.
BAnERY
MODEM
#2-x%
IF NO PULSE
LOW
DEVICE ID
Setup mode message for device ID option.
ENERGY SEQUENCE
Seitenansicht 78
1 2 ... 74 75 76 77 78 79 80 81 82 83 84 ... 91 92

Kommentare zu diesen Handbüchern

Keine Kommentare