Medtronic Guardian Real-time Betriebsanweisung PDF herunterladen (Seite 64)

Time since last calibration What happens

• The system will not take glucose measurements again until you enter a

new Meter BG measurement.

To calibrate your system:

1 Check the sensor icon on the screen to make sure monitor and transmitter are communicating.

•

Not communicating. Do not enter your meter BG measurement for calibration. Check the

following:

• The sensor and transmitter are correctly connected.

• The sensor has been started.

• The monitor is not too far from the transmitter.

• The transmitter is charged.

• The correct transmitter ID has been entered.

•

Communicating. Go to the next step to calibrate your system.

If there is still no communication, see the Troubleshooting and alarms/alerts chapter for information

on how to restore communication between the monitor and the transmitter.

2 Take a meter BG measurement. Immediately enter the meter BG measurement into your monitor

by following the rest of the steps in this procedure.

3 Open the ENTER BG screen.

Main > Sensor > Enter Meter BG

The ENTER BG screen shows three dashes.

4 Enter the number from your meter. The number on the screen must match the measurement from

your meter, and values below 40 mg/dL (2.2 mmol/L) or above 400 mg/dL (22.2 mmol/L) cannot be

used for calibration.

5 Press ACT. The calibration has been successfully entered. It takes 10-15 minutes after entering your

meter blood glucose value for the measurement to be accepted, and for the system to show those

values.

If you enter an incorrect calibration value:

1 If you enter an incorrect calibration value, immediately re-enter the correct value (if two values are

entered within 15 minutes of one another, the system uses the most recently entered value).

Using your system 49

Chapter 6

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 183 184

Keine Kommentare

Medtronic Guardian Real-time Betriebsanweisung Seite 64